Pilot operated check valve without manual emergency operation, G 1/2" (female thread / male thread)
Item number:
STOP 12
Example illustration
Item description
Materials:
Body: Aluminium anodised and galvanised steel, seals: NBR
Temperature range:
-10 to +70 °C
Operating pressure:
1 to 10 bar
Media:
oiled and unlubricated, filtered compressed air, neutral and non-hazardous gases
Function:
The check valve function can be used for a brief intermediate stop of an actuator. If there is a control signal on the actuating connection, the flow between the banjo and male threads is possible in both directions. If there is no control signal, the valve locks the flow from the male thread to the banjo (venting the actuator), thus causing it to stop briefly. The flow from the banjo to the male threads (towards the actuator) is unaffected by the control signal.
Properties
Ver­sion with­out man­ual emer­gency op­er­a­tion
Thread input G 1/2"
Thread out­let G 1/2"
Thread ac­tu­a­tion M 5
Con­trol pres­sure [bar] 0,8 - 10
Man­ual over­ride for retro­fitting STOP HN 1812
Further information:
Weight 165 g / pcs
GTIN 4050571647995
Customs duty number 84812090
Drawing:
Drawing: Application examples
Drawing: Application examples
Landefeld Druckluft und Hydraulik GmbH · Konrad-Zuse-Straße 1 · 34123 Kassel · Germany
All data are to be understood as non-binding reference values! We do not assume liability for any data selection not confirmed in writing. Unless otherwise specified, pressure values refer to liquids from Group II at +20°C.
As of: 07.06.2025