Powerful, right-hand cutting sheet metal peeling drill / step drill with sharp drill point (cross ground in accordance with DIN 1412 C) for drilling holes in sheet metal up to 4 mm thickness. The sharp drill tip makes it possible to drill into thin-walled materials without pre-drilling. The deep-ground flute (spiral flute on step drills) ensures absolutely smooth running and high cutting performance. With the step drill, the next higher step can be used to deburr the hole.
Quality:
HSS-G:
Use for steel, cast steel alloys and non-alloys, grey, malleable, ductile and cast iron, sintered iron, nickel silver, graphite, short cutting aluminium alloys, brass, bronze and plastics
Properties
Version
sheet metal drills (single drills)
Diameter [mm]
3 to 14
Sizes
1
Total length [mm]
58
Shaft diameter [mm]
6
Further information:
Weight
28 g / pcs
GTIN
4050571165079
Customs duty number
82075060
Manufacturer
RUKO
More information on this item and the process for ordering it can be found in our online shop https://www.landefeld.com under item number BOHR BS1 HSS.
All data are to be understood as non-binding reference values! We do not assume liability for any data selection not confirmed in writing. Unless otherwise specified, pressure values refer to liquids from Group II at +20°C.
As of: 05.06.2025
An error has occurred!
An error has occurred, please reload this page and try again.