Body: Aluminium anodised and galvanised steel, seals: NBR
Temperature range:
-10 to +70 °C
Operating pressure:
1 to 10 bar
Media:
oiled and unlubricated, filtered compressed air, neutral and non-hazardous gases
Function:
The check valve function can be used for a brief intermediate stop of an actuator. If there is a control signal on the actuating connection, the flow between the banjo and male threads is possible in both directions. If there is no control signal, the valve locks the flow from the male thread to the banjo (venting the actuator), thus causing it to stop briefly. The flow from the banjo to the male threads (towards the actuator) is unaffected by the control signal.
Properties
Version
Manual override for retrofitting
Thread actuation
M 5
Further information:
Weight
7 g / pcs
GTIN
4050571648107
Customs duty number
84812090
Drawing:
Zeichnung: Anwendungsbeispiel
Zeichnung: Anwendungsbeispiel
More information on this item and the process for ordering it can be found in our online shop https://www.landefeld.com under item number STOP HN 1812.
All data are to be understood as non-binding reference values! We do not assume liability for any data selection not confirmed in writing. Unless otherwise specified, pressure values refer to liquids from Group II at +20°C.
As of: 20.07.2025
An error has occurred!
An error has occurred, please reload this page and try again.